62" x .0065-.060" Stamco Vertical Aluminum Slitting Line: S-305

Manufacture

• Monarch-Stamco
• new 1997
• upgraded 2008

Material

• All common Aluminum alloys and clad products
• Full hard to dead soft temper range

Strip Width

• 24 - 62" (entry)
• 60 - 2" (exit)

Strip Thickness

• .0065 - .060"

Entry Coil Size

• ID - 16, 20, 24"
• OD - 100"
• Weight - 40,000 lbs
• Unwinding = overwind only

Exit Coil Size

• Min cut = 2”
• ID - 16, 20"
• OD - 36" max for 2-3" wide cuts / 40" max for 3-6" wide cuts / 48" max for 6-12" wide cuts / 75" max above 12" wide cuts
• Weight - 25,000 lbs max (each recoiler)
• Winding: Over and under wind capable (in any combination)

Slitter Capabilities

• Arbor Size - 6.50" diameter
• Maximum incoming width: 62”
• Minimum incoming width: 24”
• Maximum trim width: 60”
• Minimum slit width: 2”
• Cuts:  .0065”-.030” (8 cuts maximum) / .031” - .060” (6 cuts maximum)
• Maximum side trim width: none as trim can be wound to winder
• Minimum side trim width: .50”

Line Speeds

• Low Gear – 500 fpm maximum
• High Gear – 1000 fpm maximum

Hand of Line

• Right to Left

Control System

• GE 90-30 PLC

Drives

• Siemens Simoreg

Line Description

• Single Uncoiler
• Dual Recoilers
• Vertical Pass Slitting
• Light/Medium Gauge aluminum

Basic Line Equipment:

• Unwind Reel Drive – 100 HP DC motor driven, dual speed gearbox
• Unwind Edge Guide: North American
• Unwind Pinch Roll
• Entry Shear
• (2) Stamco #6 Vertical Pass slitter heads (one in-line and one for next set-up;

exchange heads with overhead crane)

• Slitter Drive – 30 HP DC motor driven, single speed gearbox
• Trim Pull Rolls: Pneumatically driven
• Scrap Baller: 25 HP AC motor driven, single speed gearbox
• Recoiler Drives – 100 HP DC motor driven, dual speed gearboxes

Sold "as is, where is" EXW dismantled at plant, USA.

Photos are a combination of when the line was installed and in it's current dismantled state.

The line was properly dismantled by a rigging contractor!